Running wires through the firewall?
4 posts
• Page 1 of 1
Does anyone know of the locations of grommets or where holes can be drilled to run wires through the firewall? I plan on running at least one antenna cable, the PA speaker wire and wires for extra driving lights
This is an aggressive post. You probably won’t like it. It is quite doubtful that you have the taste or sophistication to be able to appreciate a post of this quality and depth.
Build Thread
Build Thread
-
KE7WOX - Veteran
- Posts: 1226
- Joined: Tue Sep 29, 2009 2:10 pm
- Location: OH, Dublin (Columbus)
- Name: Felipe G
- Vehicle Year: 2004
- Vehicle: Chevrolet TrailBlazer
- DriveTrain: 4WD
There is one on the drivers side I used for a couple wires. I think I slid one through and poked an extra hole in the grommet for the other.
they've always worked for me.
-
HARDTRAILZ - Moderator
- Posts: 6342
- Joined: Sat Sep 12, 2009 1:49 am
- Location: IN, Batesville
- Name: Kyle
- Vehicle Year: 2006
- Vehicle: Chevrolet TrailBlazer
- DriveTrain: 4WD w/ Aftermarket Locker
- Rank: Extreme Offroader
I ran mine through the big boot that carries all the other wires into the engine bay. Either that or the steering column boot. Will check when I rewire.
My Build Thread | 2006 Trailblazer LS Desert Camping Edition **SOLD**
2013 Nissan Xterra S "ReXterra"
2013 Nissan Xterra S "ReXterra"
-
Philberto - Lifer
- Posts: 2046
- Joined: Fri Sep 11, 2009 5:30 pm
- Location: CA, Oxnard
- Name: Philip Cruz
- Vehicle Year: Other
- Vehicle: Other Vehicle
- DriveTrain: 4WD
- Rank: Offroad Rated
Philberto wrote: the steering column boot.
Yep thats what I did for my Hellas and strobes that I have up front. Just poked a small hole in it and taped it up.
Build Thread
Back to stock, had fun while it lasted...
Back to stock, had fun while it lasted...
- janesy86
- Veteran
- Posts: 1291
- Joined: Thu Sep 10, 2009 2:29 pm
- Location: MA, Salem
- Name: Nick Janes
- Vehicle Year: 2007
- Vehicle: Chevrolet TrailBlazer
- DriveTrain: 4WD w/ G80
- Rank: Offroad Rated
4 posts
• Page 1 of 1