Homemade rock sliders

by **charliedeuce** » Fri May 23, 2014 10:41 am

Had some pipe and some time so i made these up, they came out good i think.

by **The Roadie** » Fri May 23, 2014 10:50 am

Nice! Nothin' says "I'm going to bang on some rocks and make noise" like rock sliders. Were they DOM or normal pipe? Specs?

by **charliedeuce** » Fri May 23, 2014 12:31 pm

Pipe was just steel 1-1/4 OD - 1/8 wall tubing. I could have made them a little longer but im happy with em.

YouTube Videos · by **Trail X** » Fri May 23, 2014 1:28 pm

So, black pipe is what you used?

Without looking close at the welds, they look pretty good.

by **ErikSS** » Fri May 23, 2014 2:26 pm

They look good. My Trailgear are 1/8" x 1 3/4". How did you make the bends?

by **charliedeuce** » Fri May 23, 2014 3:19 pm

Trail X wrote:So, black pipe is what you used?

Without looking close at the welds, they look pretty good.

Thanks, Not black iron pipe like yr thinking lol. Its structural steel pipe, But I dont know why is was already black.

ErikSS wrote:They look good. My Trailgear are 1/8" x 1 3/4". How did you make the bends?

Thanks, At work i have one of thoes PITA tube benders that goes on yr shop press. Im not a fan but it gets the job done.

by **mikekey** » Fri May 23, 2014 6:18 pm

Looks better than my paper weights, I mean rock sliders.

Offroad Trailblazers and Envoys