I'll include the license plate holder and light if you're interested.
Hi-lift not included, but the mount is.
As you can see, it will work with a rear guard, or not if you don't have one.
It lowers more than is shown in the below picture (I had a hitch shackle installed in the pass-through receiver at the moment)
Below shows the details of the hinge and receiver. It is stout, I have used it to tow a boat, and had no reservations about it. I did have to cut about 2" off the back of my tow hitch in order for it to be the correct length.
I have replaced the hinge-lock pin with an easier one, similar to below. I will include this.
More pictures here:
viewtopic.php?f=9&t=14
The bolt pattern is stock, 6x5" and fits the stock wheel with room to fit a very wide tire. It only has 3 bolts filled though, so you could easily knock out the studs and drill new bolt holes in your desired pattern. The glass does open with the tire in place.
Asking $200. Depending on the distance, shipping could be included in that price... we will work it out. Must receive full payment before shipping.
I hope this will be available in two weeks. Depends on my schedule on finishing up my rear bumper.
It's been a very good piece of equipment for me, and I hope to pass it on to a good home.
