2500HD TRE RC Sleeve

[Moots1288]

Since I have basic HD tie rods, this is definitely a better option for me.

Thanks for the write up.

No problem

[v7guy]

or savings of $89.83

http://www.amazon.com/Moog-ES3488-Tie-R ... B000C57W7C 18.97

[TBYODA]

or savings of $89.83

http://www.amazon.com/Moog-ES3488-Tie-R ... B000C57W7C 18.97

And on prime if you have it, which makes it even a bigger saving. IIRC both inter and outer are much cheaper at the moment on amazon.

[JoeyV]

Not to dig up an old thread, but I wanted to clarify something. Is the reason for reaming the sleeve due to the non-threaded part of the Moog inner tie rod being thicker in diameter? If that is the case, then if someone has the ACDelco version of the inner TR than no mod to the sleeve would be necessary?

[Moots1288]

Not to dig up an old thread, but I wanted to clarify something. Is the reason for reaming the sleeve due to the non-threaded part of the Moog inner tie rod being thicker in diameter? If that is the case, then if someone has the ACDelco version of the inner TR than no mod to the sleeve would be necessary?

Yes, oem inner have a smaller diameter, The moogs are slightly larger.

Sent from my SPH-L720 using Tapatalk

[ErikSS]

I've heard the sleeves are too big for some of the cheap china ones too. They are intended for AC Delco inner TREs.

[Norcrosski]

well I can honestly say that the raybestos hd tie rods are to small for the rc sleeves they wont even thread onto the inner so looks like ill be buying moogs

[v7guy]

I've personally had to bore out the sleeves for the moogs, it's a pia

[Norcrosski]

The sleeves are bigger than the tre won't even began to thread going to call rc tommrow

[ErikSS]

Did you buy 2500HD or just 2500 TREs?

[Moots1288]

Well we did know that they don't fit all of the 2500hd.

[ErikSS]

The main cross brand differences I've heard of have been diameter of the inner TRE. As far as I knew, the thread diameter had been fairly consistent so I'm looking for what other circumstance could he fall into.

[Norcrosski]

2500 HD

[ErikSS]

I would have thought them to all use the same thread as stock. If they didn't you couldn't replace only an inner or an outer. Could you post a pic showing the issue?

[Norcrosski]

Will once I get home at work till 2 am I went around today and every inner I can get ahold of is the same issue

[ErikSS]

Ok. My current guess is an assembly issue or the sleeve needs to be drilled. The sleeve only replaces the Jam Nut that comes on the inner TRE.

[Norcrosski]

The sleeve at the threaded section is to big for the inner tierod

[Moots1288]

It sounds like you have the wrong inner

[ErikSS]

Or the wrong sleeve.

[ErikSS]

Or the wrong sleeve. Pic please.